add:north PA print temperature and settings
The settings add:north publishes for its PA: 260–275 °C at the nozzle and 50–90 °C on the bed. Start in the middle of the range, then adjust for your printer, speed and cooling.
add:north's recommended nozzle range is about 7°C cooler than the typical PA across the 3 PA lines we track (median 260–290°C).
Print settings
| Nozzle | 260–275 °C | |
|---|---|---|
| Bed | 50–90 °C | |
| Density | 1.33 g/cm³ | |
| Diameters | 1.75 mm | |
Bars run on a fixed scale; the dashed line is the median of the 3 PA lines we track. Data from SpoolmanDB.
How much filament is on a spool
Length from the published density, for each spool size add:north sells.
| Spool | 1.75 mm |
|---|---|
| 500 g | ≈ 156 m |
| 750 g | ≈ 234 m |
| 1 kg | ≈ 313 m |
Printing Nylon (PA)
Full Nylon (PA) guide →Tough, wear-resistant and slippery, good for gears and hinges, but it absorbs moisture fast and must be printed dry.
8 add:north PA colors
- Addbor N25 - Anthracite
- Addlantis - Pastel Green
- Adura - Black
- Adura - Cold White
- Adura - Grey
- Adura - Red
- Adura - Traffic Blue
- Adura FDA - Clear
Frequently asked questions
What temperature should I print add:north PA at?
add:north lists 260–275°C at the nozzle and 50–90°C for the bed. Start mid-range, then go hotter for faster printing or better layer bonding and cooler if you see stringing.
How many meters are on a 1 kg spool of add:north PA?
About 313 m at 1.75 mm, from its published density of 1.33 g/cm³.
How many colors does add:north PA come in?
8 in the data we track, including Addbor N25 - Anthracite, Addlantis - Pastel Green, Adura - Black and Adura - Cold White.