Devil Design ABS+ print temperature and settings
The settings Devil Design publishes for its ABS+: 235 °C at the nozzle and 100 °C on the bed. Start in the middle of the range, then adjust for your printer, speed and cooling.
Devil Design's recommended nozzle range is about 6°C cooler than the typical ABS+ across the 4 ABS+ lines we track (median 238–245°C).
Print settings
| Nozzle | 235 °C | |
|---|---|---|
| Bed | 100 °C | |
| Density | 1.04 g/cm³ | |
| Diameters | 1.75 mm | |
Bars run on a fixed scale; the dashed line is the median of the 4 ABS+ lines we track. Data from SpoolmanDB.
How much filament is on a spool
Length from the published density, for each spool size Devil Design sells.
| Spool | 1.75 mm |
|---|---|
| 1 kg | ≈ 400 m |
Printing ABS+
Full ABS+ guide →A modified ABS that most brands tune for less warping, with the same heat resistance and the same need for an enclosure.
7 Devil Design ABS+ colors
- Black
- Dark Gray
- Gray
- Light Gray
- Natural
- Red
- White
Frequently asked questions
What temperature should I print Devil Design ABS+ at?
Devil Design lists 235–235°C at the nozzle and 100–100°C for the bed. Start mid-range, then go hotter for faster printing or better layer bonding and cooler if you see stringing.
How many meters are on a 1 kg spool of Devil Design ABS+?
About 400 m at 1.75 mm, from its published density of 1.04 g/cm³.
How many colors does Devil Design ABS+ come in?
7 in the data we track, including Black, Dark Gray, Gray and Light Gray.